|
|
Post by Me on May 11, 2016 23:15:03 GMT
This has happened to me several times since installing this morning. I finish my unwrap and when i save the obj the mesh disappears and when i try to load it back in the is nothing there. So far Ive lost quite a bit of time due to this issue. Any answers would be much appreciated.
|
|
|
|
Post by Remi Arquier on May 12, 2016 11:39:22 GMT
Hello
Can you tell me which version of Unfold3d do you run and on which system ?
Did you tried Unfold 3d on another system before ?
Also if you could send me your OBJ file It could help us to dolve the problem
Cheers
|
|
|
|
Post by Me on May 12, 2016 17:58:53 GMT
Network 9.0.3 [Build 2611] on Windows 10. All systems at my office are using Windows 10, but nobody else currently has this installed, and unfortunately, at this time I cannot share the .obj. I have "remedied" this by making many new iterations so if something goes wrong I can revert to something I saved a few minutes before. I was hoping this might have been a reported issue before.
|
|
|
|
Post by Remi Arquier on May 17, 2016 11:15:40 GMT
Hi.
Thank you for your informations. No this problem has never been reported. How many quads or triangles your mesh is made? I would want to know if its a heavy mesh or light mesh. Also are you saving directly on hard disk ?
|
|
